My Cart

0 items - $0.00
You have no items in your shopping cart.

FREE SHIPPING OVER $79!

How To Apply Hair Extensions

1.Wash and condition the hair thoroughly. After washing, blow dry the hair so that it is straight with no styling products (do not grease or saturate the hair with any other oils).

2.Depending on the style of the extensions, part the hair according to a specified pattern. For example, if you are doing a full head, part the hair from crown to crown; if partial extensions are used, part the hair straight across from the base of the neckline to the crown.

3.Cornrow each parted section from left to right---or in the case of a full head of extensions, cornrow the hair around the head in a circular pattern. Be sure that the braids are tight enough to hold the extensions. The style will not last with loose braiding.

4. Measure the extensions and cut them to fit the cornrow. For thicker and fuller extensions (and also depending on the quality of the hair), the hair should be doubled and in some cases tripled to increase fullness. Also in this step, you must cut and measure the thread and hook it to the needle.

5.Sew each line of extension to the cornrow by weaving the needle and thread through the thick lining of the extension as well as through the individual cornrow. This process connects the extensions to the cornrows. Be sure to pull the thread all the way through for maximum hold.
After sewing the extensions to each cornrow, tie a small knot in the thread---leaving a tiny bit hanging from the extension. This is done so that the extensions can be removed easily.

6.Style the extensions and/or remaining hair. Add moisture to the scalp if desired.

The process to apply
(1).Partition your hair across the back to make a clean line. Clip your remaining hair up so you can easily put the hair extensions on.
(2).Twist a small piece of your own hair for attaching the hair extensions.
(3).Let this small piece of your own hair go through the plastic loop.
(4).Hold the micro ring and pull the big end of the plastic loop until your own piece of hair can go through the micro ring. At this moment, the plastic loop should be completely free from the micro ring and hair extensions. Please keep this plastic loop for re-apply purpose if necessary.
(5).Pull the micro ring up to about 0.8cm to 1cm from scalp.
(6).Grip the micro ring by pliers and the hair extensions is now firmly applied on.

Remove Process
(1).Use the plier to open the micro rings and done.

The process to apply
(1).Dispart the hair into two parts.
(2).Insert a template to protect your hair and fixup.
(3).Twist the hair as a hank/strand.
(4).Encase the hair bank/strand with pre tipped hair.
(5).Put the hair connector under hair.
(6).Smoothly moved for 3 seconds.
(7).Roll with fingers,and sticky tightly.
(8).Do not make any washing or pull within 24 hour.

Remove Process
(1).Use the plier to open the micro rings and done.
(2).Energize remove the glue break use flat pliter.
(3).Separate pretipped hair from your hair.
(4).Use comb or shampoo to clean the glue residue out.

There are two methods used in the application of tape hair extensions one is the sandwich method and the other is the single method.

Sandwich Method(Lasts up to 8 weeks with proper Care & Application.)

Re-apply with super tape after 8 weeks.

1-Hair must be applied to washed unconditioned hair. Part your hair in desired area where extension needs to be applied.

2-Remove the white cover on the tape extension to expose the sticky tape.(For longer hold, the super tape can be applied) Warm the tape with hair dryer or flat iron before applying to hair. Line up the extension directly even with the scalp and attach by pressing to piece of desired hair.

3-You then double the thickness by adding another layer to the underneath of the piece.

4-The two sticky sides will be facing each other and your section of hair will be in the middle.

5-Again, Apply heat by blow dryer or flat iron to seal.

6-You are finished! Your hair is now thick and seamless! Do not wash hair for three days after application.

Single Application(Last up to 2 weeks with proper care & application.)

1-Hair must be applied to washed unconditioned hair. Part your hair in desired area where extension needs to be applied.

2-Remove the white cover on the tape extension to expose the sticky tape.(For longer hold, the super tape can be applied) Warm the tape with hair dryer or flat iron before applying to hair. Line up the extension directly even with the scalp and attach by pressing to piece of desired hair.

4-The sticky side will be facing your scalp..

5-Again, Apply heat by blow dryer or flat iron to seal.

6-You are finished! Your hair is now thick and seamless! Do not wash hair for three days after application.